    |
01. Throttle Potentiometer - connect to the Efi wiring loom. 02. & 04. BThe flame trap is normally on the RH rocker cover, a hose goes from there to a ‘T’ piece, one branch to the small connection on the plenum (4) the other branch to the throttle housing (2). 03. Connect the throttle housing heater (3) to wherever the GTV8 vent hose from the manifold goes. 05. Stepper motor connection - There is a square, four-pin plug in the wiring loom to connect to the stepper motor. 06. Brake Servo vacuum 07. Cruise control - Blank this one off. 08. Fuel Pressure regulator - Make sure the vacuum hose isn’t split. 09. Fuel return - Run the fuel return to the small connection on the fuel tank 10. Fuel Supply - The fuel supply hose from the HP filter - you could cut the nut off and attach the hose with a clip but a proper hose with a screwed connection is better. You don’t really want this falling off the fuel rail. 11. Engine speed signal - connect this to the coil – same position as the rev counter wire. 12. Vacuum advance feed for Distributor 13. Outlet straight to top of water pump? But no obvious heater valve anywhere? |